Wall Plate In Roof Construction

There are two basic methods of pitched roof construction.

Wall plate in roof construction.

Wall plate 1 a horizontal member usually timber bolted or otherwise fixed to the top of a wall to which the roof framing is fixed. When fixing the wall plates down onto the brickwork if the building is square rectangle measure from corner to corner diagonally. The ridge is a long board at the top that the rafters are nailed to. Rafters are beams that run from the peak of the roof to the top plate of the supporting walls.

The rafter is cut so it sits down onto the wall plate which is in turn fixed down onto the inside skin of a cavity wall. A cut roof this is the traditional method of cutting the timber on site and building up the roof using rafters ridge boards joists and purlins etc the exact details being determined by the size of roof size of timbers etc. These are typically 1 2 m long with a cranked end and are fixed to the wall plate at 2 m centres. Pitched roof construction.

2 a horizontal member such as a steel plate fixed to a masonry or concrete wall to carry the end of a beam or to attach a beam to other members. Building a pitched roof traditional joinery method with gable walls. They join at the peak of the roof by connecting to the opposing rafter or to a ridge beam that runs the length of the peak of the house or shed. A second layer of dimensional lumber is always fastened to the top plates of the erected.

Are used without framing. One of the first stages of construction is fixing the wall plate. Its purpose is to allow easy fixing of all further timber at the wall. This is simply a timber beam that is fixed to the top of all the walls typically by nailing through it directly into the brickwork below.

Upper wall plate top plate or ceiling plate upper wall plate which is fastened along the top of the wall studs before the wall is lifted into position and on which the platform of the next story or the ceiling and roof assembly rest and are attached. Where trussed rafter roofs are not subject to uplift a minimum of two 4 5mm x 100mm galvanized round wire nails skew nailed one on each side of the trussed rafter or truss clips fixed in accordance with the manufacturer s instructions are acceptable. Generally wall plates are in lengths of not less than 3 m. The ceiling joists span from wall plate to wall plate and are sometimes bolted to the rafters to help stop the ridge.

Rafters are installed piece by piece during the construction of the roof. As the mortar does not bond the wall plate to the wall steel straps are used to ensure that the roof structure remains secure. Framing in construction is the fitting together of pieces to give a structure support and shape. When the measurement is equal the plates are square.

Another way when the roof is too large for that or there are not four corners is to use the 3 4 5 method shown here to make sure the corners are at a perfect 90.