Well Pump Check Valve Failure

This is called intermittent pump cycling.

Well pump check valve failure.

This enables water from your pressure tank to flow back down into the well which then reduces pressure and signals to the pressure switch to turn the pump on again and pressurize the pressure tank. If the pump motor starts too often that could be indicating something wrong with one of the following pieces of equipment. The house was pre existing but i really question the ability of the pump to hold the pressure in let alone to not have any small leaks in the piping all the way up from the well in the ground. The check valve or foot valve prevents the well pressure tank from sending water back down into the well after it has built up with water pressure.

Troubleshooting well problems is also complicated by the fact that almost all the action takes place far underground. Hello i ve lived in my home for about 4 5 years and have always wondered if the random cycling of my well pump could be do to me not having a check valve between the pump tank and the well pump. A leaky foot valve or check valve allows water to drain slowly down the well piping and flow back into the well. It could be a broken water line from the well to the house usually you ll have a wet area between the well head and the house a bad check valve just above the submersible pump at the bottom of the well a bad connector leaving the well casing or even a broken water line inside the well casing.

Buy a check valve. Each of these problems requires a pro. Diagnosing problems with a deep water well can be difficult. Pressure switch check your se.

A common cause is a failed check valve. If the valve fails water streams back down the well and the pressure switch turns the pump on again. At some point this will reduce the pressure in the pressure switch causing the pump to cycle back on to increase the pressure. Symptoms of a serious problem like no water in the house can be caused by either the well or the pump and sometimes both.